Waring Commercial MX Serie Manual De Operación página 5

6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
8. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
9. To turn the unit off, press ON/OFF
1. Before starting, make sure that the blender is unplugged.
2. With Sound Enclosure door open, place container on
blender base. Be sure container is fully seated and
that drive coupling is properly engaged. Plug blender
cord into outlet.
3. Put ingredients into container and cover it. Do not fill
above MAX line. Close Sound Enclosure door.
4. This blender is equipped with an electronic
membrane keypad. The keypad has a main power ON/OFF
HI and LO , STOP
5. Press the ON/OFF
illuminate. For continuous operation, press either LO
When finished blending, press STOP
press the PULSE
is released.
NOTE: Your MX Electronic Blender utilizes a Slow Start
pressing HI
then switch to HI
ingredients in container. Unit will not start with Sound Enclosure
door open.
6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
8. To turn the unit off, press ON/OFF
MX INTERNATIONAL – SOUND ENCLOSURE INSTRUCTIONS
Important Notice: Sound Enclosure is equipped with a safety interlock and
will not operate unless the door is in the closed position.
SOUND ENCLOSURE
Your MX Series blender is equipped with a heavy-duty polycarbonate
sound enclosure to reduce noise level while blending. The sound enclosure
MX ELECTRONIC TOUCH PAD SWITCHES
WITH SOUND ENCLOSURE AND INTERLOCK
and PULSE
button to turn on the blender. Green LED will
button; motor will run on HI
, the unit will start in the "Low" speed for 2 seconds and
speed. This allows for a more even blending of
button. Green LED light will go off.
buttons.
. For momentary operation,
button. Green LED light will go off.
4
button, and
or HI button.
speed until the button
feature. When
™