Makita AN560 Manual De Instrucciones página 6

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Compressor air output per minute
4. Nailing frequency
5. Pneumatic tool oil
6. Adjuster
7. Magazine cap
8. Latch lever
9. Door
10. Plate
SPECIFICATIONS
Applicable nail
Dimensions (L X H X W)
Min. hose diameter
Pneumatic oil
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.................. Read instruction manual.
................. Wear safety glasses.
................. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the making pallets and wooden
boxes.
Pneumatic nailer/stapler safety
warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and
instructions for future reference.
For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
6
Explanation of general view
11. Pressure section
12. Coil support plate
13. Graduation
14. Feed claw
15. Driver channel
16. Air fitting
17. Air socket
18. Trigger
19. Hammer
20. Small rod
Model
Air pressure
Nail capacity
Net weight
General safety
END106-2
• Do not permit those uninstructed to use the tool.
• No horseplay. Respect the tool as a working
implement.
• Do not operate when under the influence of alcohol,
drugs or the like.
• Never alter the tool.
Personal protective equipments
• Always wear safety glasses to protect your eyes from
dust or fastener injury.
WARNING: It is an employer's responsibility to
enforce the use of safety eye protection equipment by
the tool operators and by other persons in the
ENE075-1
immediate working area.
For Australia and New Zealand only
Always wear safety glasses and face shield to protect
your eyes from dust or fastener injury. The safety
glasses and the face shield should conform with the
ENB109-5
requirements of AS/NZS 1336. (Fig. 1)
• Wear hearing protection to protect your ears against
exhaust noise and head protection. Also wear light but
not loose clothing. Sleeves should be buttoned or
rolled up. No necktie should be worn.
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate the tool in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust.
Operating the tool can create sparks which may ignite
the dust or fumes.
21. Exhaust cover
22. Drain cock
23. Air filter
24. Oiler
25. Pneumatic oil
26. Thinner
27. Stove
28. Nail
29. Humid
30. Hot
AN560
0.49 - 0.78 MPa (4.9 - 7.8 bar)
Wire welded nails 27 mm - 50 mm
350 - 400 pcs.
300 mm X 280 mm X 127 mm
5.0 mm
Turbine oil
2.1 kg