System Setup - Honeywell RTH2410 Guía De Instalación Rápida

Quick Installation guide

System Setup

Follow the procedure below to personalize and
configure the thermostat according to the heating/
cooling system.
1) Press the Up and Down buttons simultaneously
(for three seconds) until the display appears as
shown below. See table on the next page.
2) Press the Up or Down button to change the
option.
3) Press the Up and Down buttons simultaneously
for one second to advance to the next function.
4) When the last function is displayed, press the Up
and Down buttons to save any changes and exit
the menu.
NOTE: If you do not press any button for 60 seconds while you are
in the setup menu, the thermostat automatically saves any changes
made and exits the menu. At any time you can save the changes
and exit by pressing the Run button.
Function
number
Option
number
12
12.