Positioning And Connection - Indesit SK 116C2 HA Instrucciones De Uso

Installation
! Before installing your new sink please read this
instruction booklet carefully. It contains important
information concerning the safe operation, install-
ation and maintenance of the sink.
! It is important to keep this booklet to be able to
consult it at any time. In the event of sale, transfer or
relocation, make sure it stays with the sink so that
the new owner has information on its operation and
the relative warnings.

Positioning and connection

! Keep all packaging material out of reach of
children. It may present a choking or suffocation
hazard. (Please see Maintenance and care? -not
sure if you need this).
! Installation must be carried out in accordance with
these instructions and by professionally qualified
personnel. Incorrect installation may cause damage
to persons, animals or property.
Instructions for installing the mixer
The sink has perforation positions (marked by col-
oured adhesive) where the mixer can be installed.
Choose the mixer installation position with care, in
relation to the installation position of the sink itself.
To open your hole for mixer installation, simply knock
a screwdriver with a hammer on the point chosen.
Clean the rim of the hole with a file.
! Perforation to install the mixer is irreversible, so
take great care.
! Once the surface of the sink has been perforated,
be careful to use protective gloves.
Instructions for installing the sink
1 Prepare the
sink with the
drain in-
stalled (see
Fig. A).
Fig.A
2 Apply some silicon along the entire perimeter of
the sink so that it projects 2-3 mm over the
edge (see Fig. B).
Fig.B
3 Insert the sink in the cut-out.
4 Insert the hooks (in the kit) in the appropriate
holes in the sink.
5 Tighten the hook
screws with the
screwdriver to definit-
ively anchor the sink.
6 Remove any residual
silicon outside the edge
of sink.
EN
Edge of sink
Silicon
2-3 mm
7