Rear; Operation; Basic Operation - Toa WT-5800 Instrucciones De Uso

[Rear]

9. Antenna input A, B
For signal routing A. Input: 75 Ω, BNC
For the wireless system covering a relatively
narrow area, use the supplied two rod antennas,
which should be set up at a 45° angle outwards
from a vertical line.
10. Antenna distribution output A, B (WT-5800
only)
75 Ω, BNC
11. Cable hanger
Hook the power cable onto this part.
Power cable
12. DC input jack
Connect the power cable of the supplied AC
adapter to this jack.

6. OPERATION

6.1. Basic Operation

Step 1. Turn the power on, and the LCD screen comes to display the receiving frequency and RF/AF levels.
Step 2. Set the microphone switch to the ON position.
The reception lamp lights when the tuner receives the same frequency signal.
Step 3. Adjust the volume control.
The output level increases as the control is rotated clockwise, and decreases as rotated counter-
clockwise.
ANT B DC IN I/O
IN OUT
12 18V 270mA max
9 10 11 12 13 14
ANT B DC IN I/O
IN
12 18V 250mA max
9 11 12 13 14
Cable hanger
AF PEAK BTT ANT
A B
UHF WIRELESS
DIVERSITY WIRELESS TUNER WT-5800
Reception lamps
OUTPUT 600 MIX IN 10k
BALANCED
UNBALANCED UNBALANCED
-20dBV
LEVEL
1 2
LINE MIC HOT HOT
3
COLD
-20dBV -60dBV
15 16
OUTPUT 600 MIX IN 10k
BALANCED
UNBALANCED UNBALANCED
-20dBV
LEVEL
1 2
HOT
LINE MIC HOT
3
COLD
-20dBV -60dBV
15 16
13. I/O port
Used for service only.
14. AF output
–20 dB*/–60 dB* selectable, unbalanced, phone jack.
15. AF output level selector
Sets the output level from the AF outputs by
selecting either MIC (–60 dB*/600 Ω) or LINE
(–20 dB*/600 Ω).
16. AF output
–20 dB*/–60 dB* selectable, balanced, XLR
connector, male type (pin #2: Hot)
17. AF mixing input
–20 dB*, 10 kΩ, unbalanced, phone jack.
Connects to other unit's AF output.
VOLUME
0 10
3
ANT A
WT-5800
OUT IN
17 10 9
ANT A
WT-5805
IN
17 9
UP
POWER
SET
DOWN
1
* 0 dB = 1 V
5