US Blaster USB 7127 Manual Usuario página 7

USB 7127-7128
Professional Power Amplifiers
The following instructions describe the most common ways to install your amplifier into a sound sys-
tem.
1. Turn off the amplifier power switch before making any connections.
2. These amplifiers maybe operated in one of three modes (stereo, bridged-mono, and parallel
mono). Re fer to the following wiring diagrams for the speaker connections you wish to make.
(Note: Aolong Systems assumes no liability for damaged speakers resulting from improper wiring,
careless amplifier use, or over powering.)
• Stereo (Two-Channel) Mode
To put the amplifier into stereo mode, first turn the amplifier off, then slide the MODE SELECTOR
SWITCH (16) to the middle "STEREO" position, and properly connect the input/output wiring as shown.
(Note: Do not connect a speaker load less than 40hms as it can damage your amplifier.)
© US Blaster Europe BV