GE JVM1850 Manual Del Propietário página 35

Replacing the light bulbs.
Remove screw
Cooktop Light/Night Light
On models JVM1850 and JVM1851, replace the
burned-out bulb with a 40-watt incandescent bulb
(WB36X10003), available from your GE supplier.
On models JVM1860, JVM1861 and JVM1870 replace
the burned-out bulb with a 120 volt, 20-watt halogen
bulb (WB36X10213), available from your GE supplier.
To replace the bulb(s), first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
2 Remove the screw at the right edge of the light
cover and push on the left edge of the cover to
open.
Be sure the bulb(s) to be replaced are cool
3
before removing. After breaking the adhesive
seal, remove the bulb by either gently turning
(for models JVM1850 and JVM1851) or pulling
straight out (for models JVM1860, JVM1861
and JVM1870). Replace with the same size and
type bulb.
Raise the light shield and replace the screw.
4
Connect electrical power to the oven.
Oven Light
Replace the burned-out bulb with a 120 volt, 20-watt
halogen bulb (WB36X10213), available from your
GE supplier.
To replace the oven light, first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
2 Remove the top grille by taking out the screws
on top of the grille that hold it in place and
sliding the grille to the left (opening the door
makes grille removal easier).
3 Next, remove the screw located above the door
near the center of the oven that secures the
light housing.
Remove the bulb from the light housing by
4
pulling straight out. Replace with the same size
and type bulb, then replace the light housing.
5 Replace the grille and screws. Connect electrical
power to the oven.
www.GEAppliances.com
35