GYS AUTOPULSE 220-M3 Manual Del Usuario página 38

JOB MODE
This mode allows you to create, save, recall and delete JOBs.
QUICK LOAD – Recall of the JOBs using the trigger when not welding.
The Quick Load is a JOB recall mode (20 max) excluding welding and possible only in MIG-MAG processes.
From a Quickload list of previously created JOBs, JOBs are recalled by pulling the trigger briefly. All trigger modes (2T/4T) and welding modes (SPOT/
STD/PLS) are supported.
OPTIONAL TORCHES
• Push-Pull Torch (4m : ref. 046283 / 6m : ref. 048713) :
The Push-Pull torch is mounted on the connector (I - 13). This type of torch allows the use of AlSi wire even in Ø 0.8 mm with a 4 or 6 m long
torch. This torch can be used in all modes.
The detection of the Push-Pull torch is done by simply pulling the trigger.
If a potentiometer Push-Pull lamp is used, the setting on the interface is used to set the maximum value of the adjustment range.
The potentiometer then allows to vary between 50% and 100% of this value.
Connection diagram for Push Pull torch
with potentiometer (10 KΩ)
1 - Choice of setting (speed or arc height)
2 - Orange LED (arc height)
3 - Green LED (speed)
4 - Increment (speed or arc according to button 2)
5 - Decrement (speed or arc according to button 2)
• Spool Gun torch* (4m : ref. 041486)
The Spool Gun torch is connected to the connector (I - 12).
This torch can be used only in synergic, standard and manual mode.
- In manual mode, the knob to adjust the wire speed is on the torch (adjustment cannot be done on the machine).
- In synergic mode, the adjusting knob enables to amend the wire speed between 50% to 100% of the interface value.
The detection of the Push-Pull torch is made by a simple press on the trigger.
Procedure of reel assembly on Spool Gun torch :
5
38
AUTOPULSE 220-M3
*not available for 208/240V model.
1- Button opening/closing casing
4
2- Reel tightening nut
3- Reel break nut (do not tighten too much)
4- Adjsutment screw for rollers tension
5- Adjustment knob for speed wire
- Open the case (1), remove the support nut (2).
- Untighten the reel brake nut (3).
- Insert your reel.
- To insert the wire in the rollers, put a tension on the «adjustment screw for rollers
tension (4)»
- Remove the torch wire by reeling the reel.
1 2 3
- Plug in the Spool gun command connector and power connector
+ supply (4) +supply (10)
3 2 1
7 6 5 4
10 9 8
logic gnd (5) analog gnd (3)
(53068)
1
2
3
5 4
EN
(1)
+
cursor (2)
M
-
(8)