Sears Craftsman 320.10871 Manual De Usario página 29

/_ WARNING:
Attempting to make cuts without the bevel adjustment locking
lever securely tightened can result in serious injury.
z_ WARNING:
To ensure safety and reliability, all repairs - with the exception
of the externally accessible brushes - should be performed by a qualified service
technician at a Sears Service Center.
z_ WARNING:
For your safety, ALWAYS turn off switch and unplug circular
saw from the power source before performing any maintenance or cleaning.
It has been found that electric tools are subject to accelerated wear and possible
premature failure when they are used to work on fiber glass boats and sports cars,
wallboard, spackling compounds or plaster.. The chips and grindings from these
materials are highly abrasive to electrical tool parts, such as bearings, brushes,
commutators, etc. Consequently, it is not recommended that this tool be used for
extended work on any fiberglass material, wallboard, spackling compound or
plaster. During any use on these materials, it is extremely important that the
tool is cleaned frequently by blowing with an air jet.
/
/_ WARNING:
Always wear safety goggles or safety glasses with side shields |
during power tool operations, or when blowing dust. If operation Is dusty, also wear
J
a dust mask.
ROUTINE MAINTENANCE
/_ WARNING:
DO NOT at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact with plastic parts, Chemicals can
damage, weaken or destroy plastic, which may result in serious personal injury.
Periodic maintenance allows for long life and trouble-free operation. A cleaning,
lubrication and maintenance schedule should be maintained. As a common
preventive maintenance practice, follow these recommended steps:
1 When work has been completed, clean the tool to allow smooth functioning
of the tool over time.
2 Use clean damp cloths to wipe the tool.
3 Check the state of all electrical cables.
4 Keep the motor air openings free from oil, grease and sawdust or woodchips,
and store tool in a dry place_
5 Be certain that all moving parts that are exposed are well lubricated, particularly after
lengthy exposure to damp and/or dirty conditions.
29