Setting Up The Av Transmitter - Marmitek GigaView 545 Modo De Empleo

SETTING UP THE AV TRANSMITTER

1. Connect the RCA cable to the AV jack at the back of the AV
transmitter [2].
2. Connect the other end of the cable to the Audio/Video OUT jacks
of the video source you want to transmit the signal from (e.g.
your VCR, DVD, Satellite or TV: connecting the transmitter to
your VCR or Satellite receiver, allows you to choose channels
independent from your main TV). If your video source is
equipped with a SCART connector use the SCART Adapter
labelled Transmitter.
3. Switch your ID code switch [7] to CH1.
4. Switch the power slide switch to 'OFF'.
5. Connect the DC plug of the adapter to the DC jack, [1] at the
back of the AV Transmitter and connect the adapter to an outlet.
Only use the supplied power adapter!
6. Switch the power slide switch to 'ON'.
7. The power LED [8] will go on.
8. Position the AV transmitter in a convenient location, preferably
free on all sides. Make sure the antenna [6] is placed vertical.
4 © MARMITEK