Setting Up The Av Receiver - Marmitek GigaView 545 Modo De Empleo

SETTING UP THE AV RECEIVER

1. Connect the RCA cable to the AV jack at the back of the AV
receiver [4].
2. Connect the other end of the A/V cables to your TV. If your TV
has a SCART connector, you may use the SCART adapter provided,
labelled "Receiver".
3. Switch your ID code switch [7] to CH1.
4. Switch the power slide switch to 'OFF'.
5. Connect the DC plug of the adapter to the DC jack, [1] at the
back of the AV Receiver and connect the adapter to an outlet.
Only use the supplied power adapter!
6. Switch the power slide switch to 'ON'.
7. The power LED [8] will go on.
8. Position the AV Receiver in a convenient location, preferably free
on all sides. Make sure the antenna [6] is placed vertical.
GIGAVIEW 545
5