Fountain Components - Sephra CF44R2 Manual De Instrucciones

SAVE THESE INSTRUCTIONS

FOUNTAIN COMPONENTS

1. Crown—Fits on top of the cylinder and sits on top of the stabilizer. On Aztec and
Cortez fountains, this is attached to the first tier (2a).
2. Tiers—Slide down the cylinder to rest into place. Tiers slope downward to create the
various fondue "curtain" levels.
a.) First Tier (Top)—Attached to the crown on Aztec and Cortez models.
b.) Second Tier
c.) Third Tier (Bottom on Montezuma, Aztec, and Cortez models)
d.) Fourth Tier (Bottom on Sephra model)
3. Cylinder—Rests inside sleeve located in the center of the basin.
4. Auger—Sits inside the cylinder and carries fondue to the top of the fountain,
creating a constant flow of fondue from the top of the crown down to the basin.
5. Stabilizer— Black plastic piece with a slit in one side that fits over the auger knob
and rests inside the top of the cylinder under the crown. Helps keep the auger
centered in the cylinder, reducing noise.
6. Cylinder Sleeve—Fixed onto fountain basin; supports cylinder.
7. Removable Basin—Holds the fondue. Twists off for easy cleanup. The basin is
directly over the internal heating element.
8. Fountain Base
a.) Base Housing—Surrounds the electrical components, including the
motor.
b.) Vent Holes—Allow hot air produced by the motor and heating element to
escape, cooling the electrical components. Vent holes should never be
covered during use.
9. PREHEAT/OFF/START Toggle Switch—Activates power to the fountain. PREHEAT
turns on the heating element only; START turns on both the heating element and the
motor, causing the auger to turn and the fondue to flow; OFF shuts off both the heat
and the motor.
10. Temperature Dial—Allows you to select appropriate heat setting (1-10) for fondue.
11. Fuse Housing—Encases the fuse that protects the motor from power surges.
12. Leveling Feet (3)—Screw into bottom of fountain base. These may be loosened or
tightened to raise or lower a particular side of the fountain for leveling.
13. Decorative Legs—Fixed to sides of fountain base for enhanced visual presentation.
14. Base Screen—Protects fountain's internal components and allows air flow. Unscrews
for access into base for maintenance purposes.
2