Step 10: Place The Boundary Flags - Petsafe PIG19 Manual Del Producto

Cross Hard Surfaces
(driveways, sidewalks, etc.)
• Concrete Driveway or Sidewalk (9C): Place the
boundary wire in a convenient expansion joint or
create a groove using a circular saw and masonry
blade. Place the boundary wire in the groove and
cover with an appropriate waterproofing compound.
For best results, brush away dirt or other debris before
patching.
• Gravel or Dirt Driveway (9D): Place the boundary
wire in a PVC pipe or water hose to protect the
boundary wire before burying.

Step 10: Place the Boundary Flags

The boundary flags are visual reminders for your pet of where the warning zone is located.
1. Place the test light contacts on the contact points. Hold the receiver collar at the height of your pet's neck (10A).
2. Walk towards the warning zone until the receiver collar beeps (10B).
3. Place the boundary flag in the ground along the boundary wire (10C).
4. Walk back into the pet area until the beeping stops.
5. Repeat this process along the warning zone until it is marked with boundary flags every 3 m (10D).
Note: If you cannot hear the beep, refer to the test light instructions in Step 8. To prevent an unintended stimulation,
after the boundary flags have been placed, be sure to set the static stimulation on the receiver collar back to level 1,
which is tone only.
10A
Follow all safety instructions for your power tools. Be sure to always wear your
safety goggles.
10B
Boundary
Wire
9C
10C
petsafe.com
9D
10D
Boundary
Wire
3 m
19