Key Definitions - Petsafe PIG19 Manual Del Producto

Key Definitions

Fence Transmitter: Transmits the signal through the boundary wire.
Pet Area: The area within your garden where your pet can roam freely.
Warning Zone: The outer edge of the pet area where your pet's
receiver collar begins to beep, warning him not to go into the static
stimulation zone.
Static Stimulation Zone: The zone beyond the warning zone where
your pet's receiver collar will emit a static stimulation, signalling him to
return to the pet area.
Boundary Width: The combination of the warning zone and the static
stimulation zone.
Receiver Collar: Receives the radio signal from the boundary wire.
Mode Button: Turns the receiver on/off and adjusts the level of static
stimulation that your pet receives outside the pet area.
Receiver Indicator Light: Indicates the level of stimulation at which
the receiver collar is set. This light also indicates battery status.
Contact Points: Delivers the safe static stimulation when your pet
moves into the static stimulation zone.
Receiver Charger: Charges the batteries inside the receiver collar.
Receiver Charge Jack: The connection point for charging the
receiver battery.
Power Jack: Where the power adaptor plugs into the
fence transmitter.
Boundary Control Switch: The switch located on the fence
transmitter to adjust according to the length of boundary wire used.
Ground Terminal: The terminal where the ground wire connects to
the fence transmitter.
Boundary Wire Terminals: Where the boundary wires connect to
the fence transmitter in order to complete a continuous loop.
Loop Indicator Light: Indicates that the boundary wire makes a
complete loop, enabling the signal to be transmitted.
Boundary Width Control: Adjusts the width of the warning and
static stimulation zones. Note: Adjusting this knob does not change
the level of static stimulation on the receiver collar.
6
Receiver Collar
Fence Transmitter
petsafe.com
Pet Area
Static
Stimulation
Zone
Boundary
Warning
Zone
Receiver Charge Jack
Mode Button
Boundary Control Switch
Power Light
Boundary Width
Control
Boundary Wire
Loop Indicator Light
Power
Jack
Width
Contact
Points
Receiver
Indicator
Light
Ground
Terminal
Terminals