Dyson AM10 Instrucciones De Seguridad página 8

Ocultar thumbs Ver también para AM10:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Once a month
(and before/after storage)
Turn the machine into standby mode/'OFF'.
Unplug from the mains electricity supply.
14
1
Unclip the loop amplifier surround: pull from
the lower edge by hand, gently but firmly.
15 mins
4
Empty the water tank. To release the water chimney, twist
the dial a quarter of a turn. Lift out. Clean thoroughly by
immersing in the citric acid solution for 15 minutes. Rinse
and wipe over all surfaces. Repeat if necessary. Refit in
reverse order, twisting the dial a quarter of a turn to secure.
7
Empty the trough of any water, small spillages may occur.
While not dangerous, care should be taken to avoid water
entering the inlets. Clean thoroughly, using the recommended
acid citric solution. Do not rinse under the tap or put in a
Some cleaning chemicals are harmful to the machine
and should not be used. Use of these may invalidate
your warranty. Do not use: Alcohol and strong acid
mixes, solvent (acetone) and oil based products, alkali
bleach mixes, air fresheners, aroma oils, scented oils,
hot water, brushes, abrasive materials, etc. Please do
not put in a dishwasher or close to a fire.
2
Using a damp cloth, wipe over both sections with the
1
citric acid solution. Do not put in a dishwasher or rinse
2
under the tap.
1
1
2
1
5
To remove the seal, pinch the securing tabs together and pull
out. Clean thoroughly by immersing in the recommended
citric acid solution for 15 minutes. Rinse and wipe over all
surfaces. Repeat if necessary. To refit, push back in so the
tabs click and the fit is secure.
Piezo
15 mins
UV-C emitter
dishwasher. Fill the trough with the recommended acid citric
solution until the UV-C emitter and piezo are submerged.
Leave for 15 minutes. Drain, rinse and wipe over all surfaces.
Repeat if necessary.
3
To attach the loop amplifier surround, lie flat and align
the surround to the main amplifier. Push firmly until it
clicks into place as shown.
15 mins
6
Pour in the recommended citric acid solution. Replace the
cap and shake tank for 30 seconds. Then leave to stand.
After 15 minutes, empty the tank. Rinse and wipe over all
surfaces. Repeat if necessary.
8
Re-assemble. Wipe the exterior with a lint-free
microfiber cloth. Switch 'ON': the water treatment
procedure starts. After 3 minutes the machine will
start to humidify.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido