Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ra, ubique la
la distancia
ferior de la
:ancia debe ser
ealizar un
;las instruc-
que aparecen
s y ajuste
_rio, hasta que
edar bien nive-
rfectamente
:lora deben
unta anterior
:la punta pos-
_uentre en su
iladas. Pro-
envuelva ias
haga ambas
ici6n m&s alta.
s de la cuchilla
ede apuntando
Mida la distan-
anterior y el
Dry el sue!o.
J
de la cuchilta
que la punta
; adetante del
6" o de calibre
&ndole varias
a de ajuste B.
o de calibre
Lde ajuste de la
sent!do horario
te adelante de
antihorario
TO OPERATE
MOWER
Your tractor
is equipped
with an operator
presence
sensing
switch.
Any attempt
by the operator
to leave the seat with the
engine running
and the attachment
clutch
engaged
will shut off the engine.
You must
remain fully and centrally
positioned
in the
seat to prevent the engine from hesitating
or cutting off when operating
your equip-
ment on rough, rolling terrain
or hills.
1.
Select desired
height of cut with at-
tachment
lift lever.
2.
Start mower blades
by engaging
at-
tachment
clutch
control.
TO STOP
MOWER
BLADES
-
disengage
attachment
clutch control.
_CAUTION:
Do not operate
the mower
without
either the entire grass catcher,
on mowers
so equipped,
or the deflector
shield (S)in
place.
REVERSE
OPERATION
SYSTEM
(ROS)
Your tractor
is equipped
with a Reverse
Operation
System
(ROS). Any attempt
by
the operator
to travel in the reverse
direc-
tion with the attachment
clutch engaged
will shut off the engine unless ignition
key
is placed in the ROS "ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
,_WARNING:
Backing
up with the at-
tachment
clutch engaged
while mowing
is strongly
discouraged.
Turning
the ROS
"ON", to allow reverse
operation
with the
attachment
clutch engaged,
should
only
be done when the operator
decides
it is
necessary
to reposition
the machine
with
the attachment
engaged.
Do not mow in
reverse
unless
absolutely
necessary.
USING THE REVERSE
OPERATION
SYSTEM
-
Only use if you are certain
no children
or
other bystanders
will enter the mowing
area.
1. Depress
brake pedal all the way down.
2. With engine
running,
turn ignition
key
counterclockwise
to ROS "ON" posi-
tion.
3,
Look down and behind
before and
while backing.
4.
Slowly depress
reverse
drive pedal to
start movement.
5. When use of the ROS is no longer
needed,
turn the ignition
key clockwise
to engine "ON" position.
TO OPERATE
ON HILLS
_WARNING:
Do not drive up or down
hills with slopes greater
than 15 ° and do
not drive across
any slope.
Use the slope
guide provided
at the back of this manual.
o Choose the slowest
speed
before start-
ing up or down hills.
• Avoid stopping
or changing
speed
on
hills.
• If stopping
is absolutely
necessary,
push
brake pedal quickly to brake position
and engage
parking
brake.
• To restart movement,
slowly release
parking
brake and brake pedal.
• Slowly depress
appropriate
drive pedal
to slowest
setting.
, Make all turns slowly.
TO TRANSPORT
When pushing
or towing
your tractor, be
sure to disengage
transmission
by placing
freewheel
control in freewheeling
position.
Freewheel
control
is located
at the rear
drawbar
of tractor.
1. Raise attachment
lift lever to its highest
position.
2.
Pull freewheel
control
out and into the
slot and release
so it is" held in the
disengaged
position.
° Do not push or tow tractor
at more than
two (2) MPH.
. To re-engage
transmission,
reverse
above
procedure.
Transmission
Engaged
13
_ansmission
Disengaged
Publicidad
Tabla de contenido
