DPERAR
los diversos
03124
:- Enciende y
ICERO - Se
tcia adelante
a sin apretar el
.ANTE - Se
ctor hacia
S - Se utiliza
tcia atr_.s.
RE - Desen-
_ujar o arrastrar.
SERVIClO /
) hay que hac-
Drtadora.
_arga (+) o la
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor
on level surface.
Engage
parking
brake.
For ease of service there is
a belt installation guide decal on bottom
of
left footrest.
BELT REMOVAL
-
1. Remove
mower
(See "TO REMOVE
MOWER"
in this section
of manual).
NOTE', Observe
entire motion
drive belt
and position
of all belt guides
and keepers.
2.
Disconnect
clutch wire harness
(A).
3.
Remove
anti-rotation
link (B) on right
side of tractor.
4.
Remove
belt from stationary
idler (C)
and clutching
idler (D).
5.
Remove
belt from centerspan
idler (E).
6.
Pull belt slack toward
rear of tractor.
Carefully
remove
belt upwards
from
transmission
input pulley and over
cooling fan blades
(F).
7.
Remove
belt downward
from engine
pulley and around
electric
clutch (G),
8.
Slide belt toward
rear of tractor, off the
steering
plate (H) and remove
from
tractor.
BELT INSTALLATION
-
1. Install new belt from tractor
rear to
front, over the steering
plate (H) and
above clutch brake pedal shaft (J).
2.
Pull belt toward front of tractor and roll
belt around electric
clutch
and onto
engine pulley (G).
3.
Pull belt toward
rear of tractor. Care-
fully work belt down around
transmis-
sion cooling fan and onto the input
pulley (F). Be sure belt is inside the
belt keeper.
4.
Install belt on centerspan
idler (E),
5.
Install belt through
stationary
idler (C)
and clutching
idler (D).
6.
Reinstall
anti-rotation
link (B) on right
side of tractor. Tighten
securely.
7.
Reconnect
clutch
harness
(A).
8.
Make sure belt is in al! pulley grooves
and inside all belt guides and keepers.
9.
Install mower
(See "TO INSTALL
MOWER"
in this section
of manual).
27