Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 2 359 95 50
Kind of textile
Synthetic (e.g. acetate,
acrylic, viscose,
polyamide, polyester...)
Silk
Wool
Cotton
Linen
•
The table is valid for the fiber materials only. If some kind of finish
has been applied (gloss, wrinkle, relief etc.), the textile can best
be ironed at a lower temperature.
•
First sort out the fabrics according to ironing temperature: wool
with wool, cotton with cotton, etc.
•
The iron heats up quicker than it cools down. Therefore, start
ironing the articles requiring the lowest temperature such as those
made of synthetic fibers. Then progress to the higher
temperatures.
•
If the article is made of a mixture of different fibers, you must
always select the lowest ironing temperature of the composition
of those fibers. (For example an item consisting of "60% polyester
and 40% cotton" should be ironed at the temperature indicated
for polyester and without steam.)
•
If you do not know what kind(s) of fabric(s) the article has been
made of, or for delicate fabrics, find a spot which will be invisible
when wearing or using the article to try out the ironing
temperature. (Always start at a low temperature and increase to
one which gives the required results.)
•
Pure woolen fabrics (100% wool) may be pressed with the iron set
to a steam position. It is recommended to set the selector switch
on position "Cotton", apply shot-of-steam and use a dry pressing
cloth.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Temperature dial
MIN
MAX
6
Assembly page 6/36
Steam ironing
NO
YES
YES
USK SIS 32968 - 100420
Publicidad
Tabla de contenido
