How To Connect The Water Supply - Amana Manual Del Proprietário

Installing Your Refrigerator
How to Install the Handles
,.,.:.../
Stainless Steel Models
Loosen lower door clip on
refrigerator door with 1//4"
hex nut driver:
Inset't 1//u" hex nut driver
into predrilled hole at base
of handle and tighten screw.
Locate predrilled hole at
base of handle, and t?t
hollow end of handle
over lower door clip.
Insert sct'ew plug into
predrilled hole, as
illustrated.
Fit other end of handle over
upper door clip and slide
up as fat" as possible.
NO rE: If top of handle does not fit over top
clip, loosen lower clip further until fit can be
accomplished.
I
I 6Repeat steps 2 through 5 to
install freezer handle.
To remove after initial install...
Follow steps 2 through 5 in reverse order.
IMPORTANT: To avoid damage to unit, Use
a flat blade screwdriver edge wrapped in
masking tape to remove screw piugs.
How to Connect the Water Supply
] WARNING I
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before
connecting water supply. After connecting water supply, connect power.
I CAUTION I
To avoid property damage, observe the following:
• Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and
ordinances.
• Confirm water pressure to water valve is between 20 and 100 pounds per square inch. If water filter is installed, water
pressure to water valve must be a minimum of 35 pounds per square inch.
• DO NOT use a self-piercing, or 3/16"(4.8 mm) saddle valve. Both reduce water flow, become clogged with time, and may
cause leaks if repair is attempted.
• Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not overtighten.
• Wait 24 hours before placing unit into final position to check and correct any water leaks.
Matedads Needed
i ,, • Brass nut and sleeve (see literature pack)
• /4 (6 mm) outer diameter flexible copper tubing
tumgb" engtnneedecltoreacnwater • Shut-off valve (requires a 1/4"or 6 mm hole to be drilled Add
to
NOTE:
8'(2
m)
into water supply before valve attachment)
supply for creation of service loop. • Adjustable wrench
I Rem°veplastic cap (A) #'°ml1{
€ llk/
Place brass nutand sleeve on copper tube
_ J end and insert tube into valve inlet port.
• Attach nut on copper tubing to valve inlet port.
6