Sanitary-Grade Acrylic; Cleaning; Damage; Durasolid A - DURAVIT Combi-System L Manual De Instrucciones

> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with water.
> Add 2% chlorine bleach to the water in accordance with the manufacturer's instruc-
tions. (approx. 15 ml)
> Turn on the Durapearl jets for 20 seconds.
> Switch on the foot and side jets and swivel jets for 5 minutes so that all pipes are
flushed.
> Allow the water in the tub to settle for 5 minutes.
> Switch on the Durapearl jets again for 20 seconds, and then the foot and side jets
and swivel jets for 5 minutes.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Switch on the Durapearl jets for 20 seconds and the foot and side jets and swivel jets
for 5 minutes.
> Drain the water.
> Repeat the process as necessary.
7.2

Sanitary-grade acrylic

cleaning

> Clean acrylic with a soft damp cloth.
> Use the Duravit Maintenance Set for Acrylic Surfaces (Art. no. 790301 00 0 00
0000) for the occasional thorough cleaning and for removing stubborn spots.
> Remove extensive soiling with warm water and a liquid detergent, dish washing
liquid or soap suds. Do not use anything abrasive as this will cause damage.

Damage

> Remove scratches and other surface damage with the Duravit Acrylic Surface Main-
tenance and Repair Set (ID No. 790302 00 0 00 0000).
7.3

DuraSolid A

NoTIcE
> Do not use concentrated acids or alkalis (e.g. caustic soda/caustic potash/drain
cleaner).
> Avoid contact with acetone; rinse the tub with clean water immediately in case of
contact.
Damage to the product as a result of using the wrong cleaning
agent or cosmetics.
35