Twin-Star International 23MM9501 Instrucción De Montaje página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Locate Base (A) and lie down on scratch free
surface, attached the Base (A) with Completed
Assembly from step 2 using Bolts (AA) through the
pre-drilled holes and tighten.
Turn in the Adjustable Leveler (LL) into the
pre-drilled holes in the bottom of Base (A). Attached
Left Frame (F) with Base (A) using Bolts (BB) and
Washers (GG) through the pre-drilled holes in
the Base.
Hardware Used
Bolt
AA
1/4 in. x 3 in.
Bolt
BB
1/4 in. x 1 1/8 in.
Washer
GG
16mm
Adjustable Lev-
LL
eler
Allen Key
RR
4. Attach Right Panel (C) to Base (A), then tighten the
Screws (CC) through the pre-drilled holes in the
frame of Base (A).
Attach the Connection Iron (MM) to the hole of
Back Frame (E), then tighten the Screws (DD)
through the pre-drilled hole.
Hardware Used
Bolt
CC
1/4 in. x 7/8 in.
Bolt
DD
1/4 in. x 5/8 in.
Connection iron
MM
Allen Key
RR
5. Attach the Clips (II) to the holes of Middle Panel (B),
then tighten the Screws (FF) through the pre-drilled
holes. Connect the Shelf Pin (JJ) and Shelf Pad
(KK), and then turn in them to the holes of Left
Frame (F).
Hardware Used
Bolt
FF
3/16 in. x 1/4 in.
Clip (II-1,II-2)
II
Shelf Pin
JJ
Shelf Pad
KK
Fig. 3
x 4
x 2
x 2
GG
BB
x 6
Fig. 4
x 4
CC
x 1
x 1
Fig. 5
II-1
FF
x 4
x 4
x 4
x 4
5
F
A
LL
AA
MM
DD
JJ
KK

Publicidad

Tabla de contenido
loading

Tabla de contenido