Removing Or Attaching The Stand - HP MediaSmart SL4782N Guía Del Usario

3
Insert the cable clamp from the box into the
square hole on the rear of the TV.
4
Route the cables through the cable clamp.
Removing or attaching the
stand
Your TV comes with the stand attached. Reverse these
steps to attach the stand.
c
CAUTION: Use two people to disassemble
or assemble the TV.
Before removing the stand, unplug the AC power cord
from the AC power outlet, and remove any cabling.
1
Carefully place the TV panel with the glass screen
facing downward on a padded, stable table with
the TV stand extended over the edge of the table.
w
WARNING: Do not allow the stand to drop
onto the TV panel.
2
Remove the four long screws that secure the stand
(pedestal) to the rear of the TV, and then lift off the
stand.
23
Setting Up the TV