Tectro TP 20 Instrucciones De Uso página 57

Ocultar thumbs Ver también para TP 20:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
The fan speed can be adjusted by pressing the
-
Maximum setting.
-
Medium setting.
-
Lowest setting.
When the unit is switched off the most recent setting will be stored in
memory.
The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
Ensure that the unit is set in the required operating mode
Switch off the unit by pressing the
properly inserted into the wall outlet.
Press the
-button. The light "Timer set" will flash.
Use the
and
When the set time has expired the unit will switch on.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
When the unit is operating in the re q u i red mode press the
The light "Timer set" will flash.
Use the
and
When the set time has expired the unit will switch off.
N O T E !
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
-button. Ensure that the plug is
buttons to set a time between 1 and 12 hours.
buttons to set a time between 1 and 12 hours.
-button
,
of
.
- b u t t o n .
4
57

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tp 25

Tabla de contenido