Final Steps For Enterprise And Cloud Start; Ethernet Gateway Setup; Using Your Wireless Sensors; For Setting Up Sensor Notifications, Other Alerts, And More Detailed Sensor & Gateway Information, Check Out The User Guide For Your System - Panduit SynapSense 900 Serie Guia De Inicio Rapido

Panduit SynapSense® 900 Series
Quick Start Guide – Enterprise and Cloud Start
Guía de inicio rápido – Empresas y en la Nube
Final Steps for
Enterprise and Cloud Start

Ethernet Gateway Setup

Power Plug
Ethernet Port
1. Connect the gateway by first attaching the
included antenna to the connector.
2. Plug an Ethernet cable with internet connectivity
into the gateway.
3. Plug the power supply (if not using POE) into a
power outlet then connect to the gateway.
4. Check that the three LED lights on the front of the
gateway change to green. Once all three lights turn
green, your network is ready to use.
If the lights do not turn green view the full User
Guide online by accessing the links at the bottom
of this guide.

Using Your Wireless Sensors

5. From the Overview Page click "View Gateways"
and check that your gateway status has changed to
active in SynapSense900.
6. From the Overview Page of your enterprise install,
click "View Sensors" to return to the sensors
overview page.
7. Check that the sensors change to active as
batteries are inserted. You may need to click the
refresh button at the top-right side of overview
©Copy Right Panduit Corp., January 2018 All Rights Reserved
00090FMD/04
Status LEDs
Control Button
8. Click on a sensor's information to access detailed
information for that sensor.
9. Click the "Edit" tab from a sensor's detail view to
change sensor settings
10. The SynapSense Cloud or Enterprise software is
now collecting your sensor data.
Note: Any change made to a sensor's settings will
be downloaded to the sensor on the next sensor
heartbeat (check-in). Once a change has been
made and "Saved," you will not be able to edit that
sensor's configurations again until the sensor has
downloaded the new setting. If you want to force a
sensor to download new settings, you can power
cycle the sensor by removing the battery, waiting
30 seconds, then reinsert the battery.
For setting up sensor notifications, other alerts, and
more detailed sensor & gateway information, check
out the user guide for your system:
Enterprise: www.panduit.com/synapsense900-
software-userguide
Cloud: www.panduit.com/synapsense900-cloud-
userguide
Page | 5