Safety Precautions; Important - SKF 721740 A Instrucciones De Uso

Read this instruction for use fully. Follow all safety precautions to avoid personal
injury or property damage during equipment operation. SKF cannot be responsible
for damage or injury resulting from unsafe product use, lack of maintenance or
incorrect equipment operation. In case of any uncertainties as regards the use of
the equipment contact SKF.
Failure to comply with the following could cause equipment damage and personal injury.
• Do ensure that the equipment is only operated by trained personnel.
• Do wear proper personal protective gear, such as eye protection and protective
gloves, when operating the equipment.
• Do inspect the equipment and all accessories carefully before use.
• Do not use damaged components or modify the equipment.
• When not in use, store the pipe in the original anti-corrosive packaging.
• Do use clean recommended hydraulic oils (SKF LHMF 300, LHDF 900 or similar).
• Do not use glycerin or water based luids as a pressure medium. Premature
equipment wear or damage can result.
• Do not use the equipment above the stated maximum working pressure.
• Do not use washers on sealing surfaces
• Do use a pressure gauge to monitor the oil outlet pressure, wherever possible.
• Do ensure that all the air has been removed from the hydraulic system before
pressurising the hydraulic system
• Do prevent the workpiece (e.g. bearing, gearwheel or similar item) from being
forcibly ejected upon sudden release of pressure (e.g. by use of retaining nut).
• Do not handle high pressure pipes when pressurized. Oil under pressure can
penetrate the skin, causing serious injury or death. If oil is injected under the skin,
seek medical attention immediately.
• Do not use damaged high pressure pipes. Avoid sharp bends and kinks when
connecting pipes. Sharp bends and kinks could internally damage the pipe leading to
premature failure. Minimum bending radius 100 mm (4 in.).
Applying pressure to a damaged pipe may cause it to rupture.
• Do not leave the equipment unattended whilst operating.
• Do follow local safety regulations
• Do replace worn or damaged parts with genuine SKF parts.
For safety reasons, high-pressure pipes have a maximum service life.
All SKF high pressure pipes are hard-marked with the year in
which their service life expires; e.g. DO NOT USE AFTER 2023.
4
READ THIS FIRST

Safety precautions

Important

SKF High Pressure Pipes