Preparation For Use - SKF TKES 1S Instrucciones De Uso

2. Preparation for use

On first use it is important that the
SD card is inserted as shown as follows:
Connect the insertion tube to the display
unit as shown in the figure and tighten
the locking collar:
Press the POWER button for 3-5
seconds to turn the display unit on.
The Start-up screen is shown briefly
followed by the status screen for five
seconds:
The status screen shows the capacity of the SD card and the internal battery.
If the TKES 1S has been stored for a long time then the display might not turn on. The
most likely cause is that the internal batteries have been fully discharged. Use the power
adapter to recharge the batteries.
6 SKF TKES 1S