Warning - Powermatic 209 Serie Manual De Instrucciones De Operación Y Partes

Warning

As with all machines, there is a certain amount of hazard involved with the use of this planer. Use the
machine with the respect and caution demanded where safety precautions are concerned. When normal
safety precautions are overlooked or ignored, personal injury to the operator can result.
Read, understand and follow the safety and operating instructions found in this manual. Know the
limitations and hazards associated with this machine.
Electrical grounding. Make certain that the machine frame is electrically grounded and that a ground
lead is included in the incoming electrical service. In cases where a cord and plug are used, make certain
that the grounding plug connects to a suitable ground. Follow the grounding procedure indicated in the
National Electrical Code.
Eye safety. Wear an approved safety shield, goggles, or glasses to protect eyes. (NOTE: Common
eyeglasses are only impact-resistant, they are not safety glasses.)
Personal protection. Before operating the machine, remove tie, rings, watch and other jewelry and roll
up sleeves above the elbows. Remove all loose outer clothing and confine long hair. Protective type
footwear should be used. Where the noise exceeds the level of exposure allowed in Section 1910.95 of
the OSHA Regulations, use hearing protective devices. Do not wear gloves.
Guards. Keep the machine guards in place for every operation for which they can be used. If any guards
are removed for maintenance, DO NOT OPERATE the machine until the guards are reinstalled.
Placement. Place machine so that potential kickback area is not in line with aisles, doorways, wash
stations, or other work areas.
Work area. Keep the floor around the machine clean and free of scrap material, saw dust, oil and other
liquids to minimize the danger of tripping or slipping. Be sure the table is free of all scrap, foreign material
and tools before starting to cut. Make certain the work area is well lighted and that a proper exhaust
system is used to minimize dust. It is recommended that anti-skid floor strips are used on the floor area
where the operator normally stands and that each machine's work area be marked off. Provide adequate
work space around the machine.
Avoid accidental starting: Make certain motor switch is in off position before connecting power to the
machine.
Operator position. Maintain a balanced stance and keep your body under control at all times. Stand to
one side out of line with the table and make sure no one else is standing in line with the table.
Housekeeping. Before turning on machine, remove all extra equipment such as keys, wrenches, scrap,
and cleaning rags away from the machine
Careless acts. Give the work you are doing your undivided attention. Looking around, carrying on a
conversation, and "horseplay" are careless acts that can result in serious injury.
Disconnect machine before performing any service or maintenance or when changing blades. A
machine under repair should be RED TAGGED to show it should not be used until the maintenance is
complete.
Maintain tools in top condition. Keep tools sharp and clean for safe and best performance. Dull tools
increase noise levels and can cause kickbacks and glazed surfaces. Check the condition and adjustment
of the tools before making any cuts. Follow the sharpening instructions on knife grinding and jointing,
installing and adjustments.
4