Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO WASH AND RINSE CONTAINER:
1.
REMOVE CONTAINER FROM MOTOR BASE. Remove lid. Rinse
container interior and lid under running water. Add washing solution to
container. Scrub and flush out the container interior and lid to dislodge
and remove as much food residue as possible. Empty container.
2.
Wipe down exterior of container with a soft cloth or sponge dampened
with washing solution. Wash lid and lid insert in fresh washing solution.
Fill container ¼ full with fresh washing solution, cover (with lid only),
place on motor base and run on the highest speed for two (2) minutes.
Empty container.
3.
Repeat step (2) using clean rinse water in place of washing solution.
NOTE: IN ORDER TO MINIMIZE POSSIBILITY OF SCALDING, TEMPERATURE
OF WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 46˚C, AND
QUANTITY USED MUST NOT EXCEED ¼ CONTAINERFUL.
IF HIGHER TEMPERATURES OR LARGER QUANTITIES ARE USED, OBSERVE
ALL PRECAUTIONS GIVEN IN THE OPERATING MANUAL UNDER "HOT
BLENDING INSTRUCTIONS".
TO SANITIZE AND DRY CONTAINER:
1.
Wipe down exterior of container with a soft cloth or sponge dampened
with sanitizing solution.
2.
Fill container with sanitizing solution, cover, place on motor base, and
run on high
residual moisture from blade assembly by placing empty container on
motor base and running on the highest speed for two (2) seconds.
3.
Sanitize lid and lid insert by immersing in sanitizing solution for two
(2) minutes.
4.
Do not rinse container, lid, or lid insert after sanitizing is completed.
Allow parts to air-dry.
TO CLEAN AND SANITIZE MOTOR BASE:
1.
UNPLUG POWER CORD. Wipe down exterior surfaces of motor base
with soft cloths or sponges dampened with washing solution, rinse
water, and sanitizing solution. Prevent liquid from running into motor
base by wringing all excess moisture from cloths or sponges before
using them.
DO NOT IMMERSE MOTOR BASE IN WASHING SOLUTION, RINSE
WATER OR SANITIZING SOLUTION.
2.
Allow motor base to air-dry before using.
Any other servicing should be performed by an authorized service
representative.
IMPORTANT
speed for two (2) minutes. Empty container. Dislodge any
12
Publicidad
Tabla de contenido
