Hauck Memphis Air Instrucciones De Uso página 18

INSTRUCTIONS FOR USE
1. Assembly
Release the transport safeguard.
Erect the pushchair by moving the slide until you can see and hear that
the locking mechanisms on both sides have engaged.
2. Mounting the wheels (fig. 2)
Fit a wheel on the front axle until you hear it click and the metal clip
has engaged in the axle groove. Check that it fits firmly. Push the axle
through the two plastic guides at the ends of the frame and fit the other
wheel. Here again, check that it fi ts firmly. Proceed accordingly with
the rear axle.
3. Brakes
To lock the foot brake, press the brake bar down with your foot.
To release it again, lift the brake bar with your foot.
Caution! Always lock the brakes when parking the pushchair.
4. Mounting the hood (fig. 3)
Push the hood in the corresponding openings to the left and right of the
pushchair superstructure.
5. Swivelling the push bar (fig. 4 a/b/c)
The push bar can be swivelled to use the pushchair with snug nest. To
do so, pull the upper adjusting lever on the push bar and move it over
to the other side at the same time. Check that it has engaged correctly.
6. Adjusting the height of the push bar (fig. 5)
Press the adjusting buttons underneath the handle on both sides and
adjust the required height. After adjusting the required height, the
buttons pop out again.
7. Adjusting the back rest (fig. 6)
To adjust the back rest, pull the metal handle at the back of the rest up
and move the back rest back.
The sitting position is achieved by pushing the back rest up until the
locking mechanism engages.
8. Adjusting the leg rest (fig. 7)
Bring the leg rest to the required position and hook the metal supports
in position under the leg rest.
18