Frequently Asked Questions - Marmitek AM12 Modo De Empleo

FREQUENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same House Code. To solve this problem try to change
the House Code of your system, or have FD10 Phase Coupler/Filter installed at
your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are set to the
same House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13
Transceiver or Marmitek Security Console installed in your house. These
components will translate the radio signals to the Marmitek X-10 signal on the
power line. Only one Transceiver should be installed for all remotes and
sensors set to the same House Code.
Am I able to increase the range of my remotes by using more
Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the
range of your remotes is not sufficient. The TM13 is using so called collision
detection to prevent signals to be disturbed when more than one TM13 is
transmitting. TM13's will wait for a quite power line before transmitting their
data. To prevent your Marmitek X-10 System to become slow or to prevent
dimming from becoming less smooth, make sure that the TM13 units are
placed as far away from each other as possible.
Do the Marmitek plug modules work in unearthed wall power points ?
Yes. The modules work both in earthed and unearthed wall power points.
My module does not respond to the 'All lights on' command.
That's right. Only lamp modules will respond to the command 'All lights on'.
This is to prevent that for instance a coffeemaker is switched on accidentally.
Apparatus modules do respond to the command 'All Units Off'.
Do you still have questions?
Please check out www.marmitek.com for more information.
AM12 7