Freqently Asked Questions - Marmitek TMD4 Modo De Empleo

Use of the MicroModules in a three-phase installation
The MicroModule send the commands once for use on the own phase.
If you want the commands sent by the MicroModules to be used on
other phases as well you need to use the CAT 3000 active phase
repeater. (Art.nr. 09304). The FD10 phase connector filters can be used
as net filters but not as phase connectors in combination with TMD4.

FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same House Code. To solve this problem try to
change the House Code of your system, or have FD10 Phase
Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are
set to the same House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one
TM13 Transceiver or Marmitek Security Console installed in your
house. These components will translate the radio signals to the
Marmitek X-10 signal on the power line. Only one Transceiver should
be installed for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using
more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when
the range of your remotes is not sufficient. The TM13 is using so called
collision detection to prevent signals to be disturbed when more than one
TM13 is transmitting. TM13's will wait for a quite power line before
transmitting their data. To prevent your Marmitek X-10 System to become
slow or to prevent dimming from becoming less smooth, make sure that
the TM13 units are placed as far away from each other as possible.
Do you still have questions? Please check out
www.marmitek.com for more information.
TMD4™ 13