Frigidaire FKOF38MDIS Manual De Instrucciones página 29

Lighting Your Grill
Before cooking on this grill for the first time, operate the grill for about 15
minutes with the lid closed and the gas turned on "high." This will "heat clean"
the internal parts and dissipate odor from the manufacturing processes and
painted finish.
Attention
Failure to open lid while igniting the grill or not waiting 5 minutes to allow the
gas to clear if the grill does not light may result in an explosive flare-up which
can cause serious bodily injury or death.
Main burners
1. Read ALL instructions before lighting.
2. Open lid before lighting.
3. Open the LP-Gas Cylinder Valve.
4. Push in main burner control knob fully and rotate slowly about 1/4 turn
counterclockwise until a click is heard.
5. If ignition does not occur, repeat step 5 in rapid succession for no more than
5 seconds or until burner ignites. If ignition still does not occur, immediately
turn the burner control(s) off, wait 5 minutes for the gas to clear and repeat
the lighting procedure.
6. Follow same steps to light left and right main burners.
After lighting, observe the burner flame and make sure all burner ports are lit.
If burner flame goes out during operation, immediately turn the gas "off" on the
grill and at the gas cylinder and open lid to let the gas clear for about 5 minutes
before re-lighting. Clean your grill aftereach use, DO NOT use abrasive or
flammable cleaners, as it will damage the parts of this product and may start a
fire.
55
Side burner
1. Read ALL instructions before lighting.
2. Open lid during lighting. Lid must be open when burner is on.
3. Burner valves must be in the "off" position.
4. Open the LP-Gas cylinder valve.
5. Push in side burner control knob fully and rotate slowly about 1/4 turn
counterclockwise until a click is heard.
6. If ignition does not occur, repeat step 5 in rapid succession for no more than
5 seconds or until burner ignites. If ignition still does not occur, immediately
turn the burner control(s) off, wait 5 minutes for the gas to clear and repeat
the lighting procedure.
7. After burner ignites, adjust control knob to desired cooking setting.
Rear Rotisserie Burner
1. Read ALL instructions before lighting.
2. Open lid before lighting.
3. REMOVE WARMING RACK BEFORE USING REAR ROTISSERIE BURNER.
4. Open the LP-Gas Cylinder Valve.
5. Push in rear rotisserie burner control knob fully and rotate slowly about 1/4
turn counterclockwise until a click is heard.
6. If ignition does not occur, repeat step 5 in rapid succession for no more than
5 seconds or until burner ignites. If ignition still does not occur, immediately
turn the burner control(s) off, wait 5 minutes for the gas to clear and repeat
the lighting procedure.
Shutting Off Burners
1. Always turn the valve knob(s) clockwise to the High position, and then push
in and turn to OFF. Never force the knob without depressing it as this can
damage the valve.
2. Promptly turn the gas supply OFF at the propane cylinder.
3. Close the lid of the grill.
56