ROSIERES RDCF 43 MIN Instrucciones De Uso Y El Mantenimiento página 28

INSTRUCTIONS FOR INSTALLATION OF THE UNIT
All tasks involved in installing the appliance must be carried out by skilled
personnel.
Any work is to be performed with the appliance unplugged.
Electrical connection:
make sure that the voltage corresponds to that indicated on the tag on the side.
The oven must be connected using a cable with a minimum cross-section of 1.5
mm on the rear, and with an omni-polar switch compliant with current standards
with a distance of aperture between contacts of at least 3 mm.
Caution:
if you need to replace the power cord, make sure you comply with the following
colour-code when connecting the single wires:
BLUE - NEUTRAL ( N )
BROWN - PHASE ( L )
YELLOW-GREEN - EARTH ( )
Attention: earth connection is required by law.
The manufacturer will in no way be held liable if accident prevention standards
area not observed.
Insertion into the furniture unit:
The appliance can be inserted either under a worktop or into a column. In either
case comply with the dimensions shown in figures 1 and 2.
For column installation, in order to ensure proper ventilation, it is indispensable to
provide an opening of at least 85-90mm as shown in figure 1.
The oven is secured to the furniture unit by four screws A located in the holes of
the perimeter frame (see fig. 1).
Do not use the door a lever when installing the oven.
Do not place excessive pressure on the oven door when it is open.
26