Installation Of The Rear Cover - Olimpia splendid Ci2 Wall Manual De Instrucciones

1. CONNECT TWO TERMINALS OF SHIELDED CABLES WITH 4 WIRES WITH
THE SWITCHING CABLES OF THE REMOTE CONTROL AND OF THE SIGNAL
RECEPTION BOARD. MAKE SURE THAT THE SEQUENCE OF 4 TERMINALS
(A / B / C / D) CORRESPONDS WITH THE SEQUENCE OF SWITCHING CABLES
OF THE SIGNAL (A / B / C / D). (fig. 3)
2. IF THE SHIELDED CABLES WITH 4 WIRES CANNOT PASS THROUGH THE
REMOTE CONTROL, IT IS POSSIBLE TO USE THE SWITCHING SIGNAL FOR
THE CONNECTION (fig. 4); MAKE SURE THAT THE CABLES ARE INTEGRAL
AND CONNECTED TIGHTLY.
3. THE COUPLING TORQUE OF THE TERMINALS IS: 0.8÷1.2Nm (8÷12 kgf x
cm).

1.4 - INSTALLATION OF THE REAR COVER

Attachment points
Screwdriver
Fig. 5.1
Hole for wall
installation
M4x20
Fig. 5.3
1. Use a flat tip screwdriver to release the retainers and remove the rear cover from the box.
Turn the screwdriver as indicated in figure 5.1 in order not to damage the cover.
2. Use three M4x20 screws to install the upper cover directly onto the wall. (Fig.5.2)
3. Use two M4x25 to install the rear cover on the electric box (switch-holder) and then use a M4x20 GB950-
86 screw to fix it to the wall. (Fig.5.3)
4. Tighten the rear cover to the electric box, making sure that the cover rests on the wall.(fig.5.4)
5. Check that the cover is aligned and then position the front cover on the rear cover.
Make sure there are no cables that could become jammed.
6. Press the front cover onto the rear cover until they are attached.
Check that the front cover is stable and correctly attached.
Rear cover
Front cover
Hole for
installation on
electric box
M4x25
Hole for wall installation
M4x20
Fig. 5.2
Electric box
Rear cover
Signal
switching
cable
Fig. 5.4
EN - 9