Cleaning And Care - Clatronic HTD 2613 Instrucciones De Servicio

43419-05-HTD 2613
GB
1. Fully unwind the mains cable.
2. Fit on a nozzle. You can dry single hair locks by concentrating the flow of hot air
with the hairdressing nozzle. The diffuser is the ideal solution to dry curly hair
without losing volume.
3. Insert the plug into a duly installed 230V/50Hz protective contact socket.
4. Shift the switch on the handle to one of the desired heat/blowing levels:
Level 0: off
Level 1: medium airflow and medium temperature
Level 2: strong airflow and high temperature
COOL-Shot
With this switch it is possible to interrupt the heating process so that the air
can be mixed according to individual requirements.
5. After use shift the switch to position 0 and pull out the plug. Leave the device to
cool before putting it away!
Clean the air suction opening from time to time with a fine brush. Clean the hou-
sing with a soft, dry cloth without additives.
Removing the air suction cover
Remove the cover after turning the cap through approximately 30 degrees against
a clockwise direction. Remove the intake filter and clean under running water. Dry
the filter well before mounting again!
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
We undertake to guarantee the appliance sold by our company for 24 months as of
the date of purchase (cash receipt).
Within the guarantee period we rectify faults to the machine free of charge which
result from material or manufacturing faults, either by repairing the machine or, or
our discretion, by replacement. Any such repair or replacement associated with the
guarantee shall not cause the guarantee period to be extended, nor be deemed to
be the start of a new guarantee period!
Proof for the warranty is provided by the purchase document. The replacement and
repair will not be performed free of charge without this proof of purchase.
24
10.03.2004 12:40 Uhr
Commissioning

Cleaning and care

Warranty
Seite 24