Aqua Medic DC Runner 1.3 Manual De Instrucciones página 8

1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Front bearing
Fig. 2: DC Runner 2.3 + 3.3
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure connections
9. Seal for pressure connections
Fig. 3: DC Runner 5.3 + 9.3
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
Available spare parts: Please refer to www.aqua-medic.de.
The pump may only be operated with
is 1 m / 40 in.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the aquarium, the power
6. EcoDrift Control
plug must be disconnected from the mains. The connection cable and the power plug must not be
changed. If the power cable is damaged, the pump must be scrapped.
7. Housing's sealing
8. Pump lock
9. Seals for pressure connections
10. Filter basket
11. Sealing plug
10. Adhesive sleeve D 25
11. Adhesive sleeve D 32
12. Hose connection pressure side
13. Hose connection suction side
14. Union nut pressure side
15. Union nut suction side
16. Filter basket
17. Sealing plug
5. Impeller rotor 9. Adhesive sleeve D 32
6. Housing's sealing 10. Hose connection
7. Pump lock 11. Union nut
8. Seal for pressure 12. Filter basket (only DC Runner 5.3)
connections
water. An installation out of water is possible. The max. water depth
8