Defort DMM-20D-RF Instrucciones De Servicio página 9

DETECTING WOOD,
METAL AND "LIVE" WIRES
Turning on
Select detection mode by pressing PUSH button.
Detection
1. The device can be operated in 4 detection modes:
STUD (soft wood)/METAL (metal)/DEEP (hard wood)/
AC (alternating current).
Each mode can be selected by pressing the PUSH but-
ton for 1÷3 seconds and the device will beep.
2. After selecting the material to be detected, place the
measuring tool on the surface and move it slowly. The
measuring tool detects the presence of the specifi ed
material in the points where maximum intensity is reg-
istered.
TEMPERATURE MEASUREMENT
Select temperature measurement by pressing C/F but-
ton.
LASER LINE
The measuring tool is equipped with a laser line to
check the surface fl atness and a built-in magnet for
attaching the device to metal surfaces.
ADDITIONAL INFORMATION
1. The appearance of battery symbol on the display
indicates battery voltage drop under 7V (±0.5V). The
battery must be replaced.
The measuring tool will operate within 5 minutes after
the appearance of this symbol.
2. Message «Err» will be displayed if you attempt to
calculate values beyond the device measurement
range.
3. The device displays the value «0.00» during the fi
rst measurement.
4. The device will beep if the signal is high.
5. If you have not pressed any button for a period ex-
ceeding 15 seconds the display will turn off and 30 sec-
ond later the device will enter standby mode.
6. Upon placing a battery in the compartment the de-
vice starts to operate in measuring mode.
7. Upon pressing any button the device will exit stand-
by mode and will display the last result.
MAINTENANCE
Store and transport the measuring tool only in its origi-
nal packing.
Always keep the measuring tool clean. Use a soft
damp cloth and mild detergent to clean the housing if
necessary.
WARNING: Never use alcohol, petrol or other cleaning
agent. Never use caustic agents to clean plastic parts.
WARNING: Water must never come into contact with
the tool.
NOTES
Carefully read the entire Original Instructions before
using this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifi
cations without prior notice.
Specifi cations may differ from country to country.
9