Electrical; Grounding Instructions; Permanent Heat Disable - Dimplex Revillusion RBF24DLX El Manual Del Propietario

Electrical

General
The fireplace is packaged with a three
(3) prong plug installed for plug-in
convenience. Hard wiring the fireplace
is also an option for installation.
WARNING: Construction and
electrical outlet wiring must comply
with local building codes and other
applicable regulations to reduce the
risk of fire, electrical shock, or injury to
persons.
WARNING: Do not attempt to wire
your own new outlets or circuits. To
reduce the risk of fire, electric shock
or injury to persons, always use a
licensed electrician.

Grounding Instructions

This product must be grounded. If it
should malfunction or break down,
grounding provides a path of least
resistance for electric current to reduce
the risk of electric shock. This product
is equipped with a cord having an
equipment-grounding conductor and
a grounding plug. The plug must be
plugged into an appropri ate outlet that
is properly installed and grounded in
accordance with all local codes and
ordinances.
DANGER ! Improper connec tion
of the equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualified electrician or
serviceman if you are in doubt as
to whether the product is properly
grounded. Do not modify the plug
provided with the product – if it will
not fit the outlet, have a proper outlet
installed by a qualified electrician.
10

Permanent Heat Disable

The fireplace heater can be
permanently disabled by removing the
electronic jumper on the main control
board. Disable the heater before any
additional installation takes place.
To permanently disable the heater:
1.
Locate and remove the panel on the
top left of the unit.
2
. Pull out the electronic jumper
(shunt), on the on the left side of
the screw in the right corner of the
board. The label beside the jumper
is "HT EN".
3.
Reinstall the previously removed
panel.
www.dimplex.com