Dimplex Revillusion RBF24DLX El Manual Del Propietario página 9

Installation
Placement
This fireplace is a zero clearance
design, with the exception of the
top of the unit, where any insulation
and vapor barrier should be placed
a minimum of 2" (5.1 cm) from the
fireplace.
DANGER !: High temperatures
may be generated under certain
abnormal conditions. Do not partially
or fully cover or obstruct the front of
the fireplace.
WARNING: All electrical heaters
have hot and arcing or sparking parts
inside. Do not use it in areas where
gasoline, paint, or flammable liquids
are used or stored.
WARNING: The electric fireplace
must NOT be in direct contact with any
building vapor barrier or insulation.
!
NOTE: If the fireplace is going into
an existing opening and used with the
trim accessory, locate the fireplace as
needed for the the best appearance.
1.
Place the fireplace into the opening.
Level with shims if necessary.
2.
From the inside of the unit, gently
remove the interior brick panels
(attached magnetically).
3
. Screw the mounting flanges directly
to the stud opening or bend the
flanges out to 90° to be flush
with the surrounding studs and
screwed to the studs using suitable
hardware.
Bathroom Installation
This electric fireplace must be
protected by a GFI circuit when
installed in an area where water is
present. If the unit is installed using
a receptacle, it must be readily
accessible.
This fireplace is not watertight and
must be installed as to prevent water
from entering the unit. Install the unit
away from showers, tubs, etc. Keep
towels and other combustible materials
3 feet (0.9 m) away from the front of
the unit.
9