Publicidad
Idiomas disponibles
Idiomas disponibles
four remote Federal strobe heads. These power supplies will provide up to 10 watts per
channel and will flash in 1 pattern selected from 7 available patterns. See table 1 for
explanation of the 7 flashing patterns. The cutoff function disables strobe heads 2 and
4.
B.
SPECIFICATIONS.
Input Voltage:
Input Current:
Input Current:
Fuse:
Dimensions:
Length
Width
Height
Net Weight
C.
INSTALLATION.
Before drilling holes in ANY part of a vehicle, be sure that both sides of the
mounting surface are clear of parts that could be damaged; such as brake
lines, fuel lines, electrical wiring or other vital parts.
The power supply housing is NOT waterproof. It must be mounted in a
location, which is sheltered from falling rain, snow, standing water, etc. Also, it
must be installed in an adequately ventilated area. Never install near heater
ducts or under the vehicle's hood.
Failure to observe this WARNING may result in fire, burns or blind-
ness.
If shorted to vehicle frame, high current conductors can cause
hazardous sparks resulting in electrical fires or molten metal.
DO NOT connect this system to vehicle battery until ALL other
electrical connections are made and mounting of all components is
complete.
Verify that no short circuits exist, before making connection to the
vehicle battery.
This unit follows a RED, BLACK, WHITE color scheme for the strobe
outputs. Ensure that red is matched to red, black to black, and white to
white when connecting the strobe heads.
DO NOT drill holes in ANY part of the power supply chassis or cover.
Damage to the unit, serious injury or death to you or others may result.
11Vdc to 28Vdc
(12.8 or 25.6Vdc nominal).
3.6 amperes (basic pattern) @ 12.8Vdc
1.8 amperes (basic pattern) @ 25.6Vdc
8.0 amperes (3AG type).
6.125" (156 mm)
4.75" (121 mm)
1.67" (44 mm)
1.2 lbs. (0.54 kg)
CAUTION
WARNING
-2-
Publicidad
