Aux-In Connection - SOUNDMASTER PL525 Manual De Instrucciones

FM & FM-stereo reception
 Press the "Mono/St" button (9) repeatedly, the FM programs are receiving in mono and
stereo mode repeatedly. In particular when stereo signals are weak. It is preferable to
receive the program in mono.
 If stereo signal is being received, the stereo indicator "
FM stereo program is now receiving.
Hints for best reception:-
FM : the receiver has a build-in FM wire antenna hanging at the rear cabinet. This wire should
be totally unraveled and extended for the best reception.
Note:
Remove the stylus protector.
-
- Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
1. Turn "Function" button (4) to select " Phono " mode.
2. Set the speed selector (19) to the proper position depending on the
record to be played.
3. Place the record on the platter (use the spindle adaptor (17) if required).
4. Lift the tone arm from the rest and slowly move it to the record side.
The platter will start to rotate.
5. Place the tone arm by the pick up holder (21) to the desired position of
the record.
6. Adjust the volume (12) to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
Remark : As some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track finish. In this case, select the auto-stop switch (20) to " off " position, then it
will run to the end of the record but will not stop automatically (turn off the unit by power/volume
knob(16)or switch back the auto-stop switch to " on " position to stop the platter rotate). Then
put back the tone arm to the rest position.
Connect the unit to any auxiliary device (i.e. MP3 player, or iPod® (not included) by connecting
the aux in jack (14) with one end of 3.5mm stereo cable(not provided)and the other end connect
to the auxiliary device to perform the music.
1. Turn "Function" button (4) to select " Aux " mode.
2. Plugged the Aux in jack from your external device.
3. Start to playback your device and adjust On-off/Volume knob (12) to the desire volume level.
If the distortion was too high, reduce the volume level of your auxiliary device.
LISTEN TO THE PHONO

AUX-IN CONNECTION

4
PL525 / English Instruction Manual
" will appear on LCD (7) to show