Removing Fasteners From The Tool - RIDGID R138HPF Manual Del Operador

OPERATION
The tool and air hose must have a hose coupling that allows
all pressure to be released from the tool when the coupling
is disconnected.
WARNING:
Always use a coupler that discharges all the
compressed air in the tool at the time the fitting or
hose coupling is disconnected. Using a coupling
that does not discharge the compressed air could
cause unintended operation and serious personal
injury.
WARNING:
Do not climb rigging or scaffolding while carrying
a tool that is connected to an air hose. Doing so
could result in serious personal injury.
Connect the tool to the air supply with a 1/4 in. female quick
connector.
WARNING:
The pin nailer is capable of driving a fastener
without making contact with a workpiece. Always
point the tool away from yourself or others and
always direct the fastener toward the work surface
before pulling the trigger. Failure to do so could
result in possible serious personal injury.
LOADING THE TOOL WITH FASTENERS
See Figures 4 - 5, page 13.
WARNING:
The tool's driving mechanism may cycle when the
tool is first connected to the air supply. Always
connect the tool to a pressurized air supply before
loading fasteners to prevent injury from unintended
cycling. Always make sure the tool's magazine
is empty at the beginning of each work session,
before connecting to an air supply.
WARNING:
Keep the tool pointed away from yourself and
others when loading fasteners. Failure to do so
could result in possible serious personal injury.
WARNING:
Use only the fasteners recommended for use with
this tool (refer to the Fastener Guide). The use of
any other fasteners can result in tool malfunction,
leading to serious injuries.
WARNING:
When loading fasteners, do not pull the dual
actuation trigger system, as accidental actuation
will occur, possibly causing injury.
 Connect the tool to the air supply.
 D epress the latch and slide the magazine open.
 Make sure the secondary trigger has locked out the
primary trigger.
 Insert the fasteners, pointed end down, into the groove
in the nail track as shown. Fasteners should sit securely
in the nail track.
NOTE: Your fasteners may be marked with an arrow,
indicating the pointed end.
 Slide the magazine to close. Make sure the latch is secure.

REMOVING FASTENERS FROM THE TOOL

WARNING:
Disconnect the tool from the air supply before
removing nails. Failure to do so could result in
serious personal injury.
 Disconnect the tool from the air supply.
 With the nose of the tool pointed away from you, depress
the latch located at the rear of the magazine and slide the
magazine open.
 Remove the fasteners.
DRIVING A FASTENER
See Figures 6 - 7, page 14.
WARNING:
Never wedge or hold back the secondary trigger
during operation of the tool. Doing so could result
in possible serious injury.
WARNING:
Do not pull the dual actuation trigger system unless
the nose of the nailer is pressed against the work
surface. Accidental actuation will occur, possibly
causing injury.
8 – English