Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Breathable flow with the Sidestream ne-
bulizer cup is increased by 140% compa-
red to a conventional nebulizer cup.
PREPARING AND
USING THE DEVICE
• Remove the device and accessories
from the pack and take the Sidestream
chamber (12)
• Unscrew the top of the Sidestream
chamber in an anticlockwise direction
(4)
• Add the medicine and/or saline solution
to the chamber tank. Use doses recom-
mended by a medical practitioner or
pharmacist
• Close the chamber, tightening the top in
a clockwise direction
• Connect the tube to the chamber (6) and
compressed air outlet nozzle
• Connect the chamber to the accessory
chosen for treatment: adult mask, pae-
diatric mask, nose fork, mouthpiece.
If you are not sure which accessory to
use, consult a medical practitioner
• Connect the device to the mains
• Turn on the device by switching the lu-
minous ON switch to position I and start
treatment
• Start inhalation. During treatment, the
chamber can be placed on its base.
• Carry out treatment preferably when
seated and in a comfortable position
• When the aerosol flow becomes inter-
mittent, stop the treatment for a few
seconds and let the droplets of medici-
ne deposit on the walls of the chamber.
Start treatment again and end the ses-
sion when all nebulised medicine has
been expelled out of the chamber
• After treatment, turn off the device, re-
move the plug from the socket, remove
the used accessory and clean the device
and accessories as indicated in the sec-
tion Cleaning and Maintenance
CLEANING AND
MAINTENANCE
Before cleaning or maintenance, always
turn off the device and remove the plug
from the socket.
Thoroughly clean the device at regular in-
tervals to ensure it stays in good working
order.
Cleaning and
maintenance of
the compressor
Caution! Do not wet or put the device into
water or other liquids. Use only a soft, dry
cloth to clean the device.
Cleaning and
maintenance of
the nebulizer cup
and accessories
Remove and separate all nebulizer cup
components and accessories, immerse in
boiling water for at least 5 minutes. Rin-
se the accessories under running water.
After cooling, disinfect parts that come
into contact with the user with denatured
alcohol.
Carefully dry all components and the de-
vice before reassembling.
Store in a cool, dry place, away from light
and heat.
Never use benzene, thinners or other in-
flammable chemical substances for clea-
ning.
For greater hygienic safety, we recom-
mend you to avoid using the same ac-
cessories for more than one person and
purchase a kit for each user (Aerosol kit
cod. 00 038405 000 000).
CHECKING AND
REPLACING FILTERS
We recommend checking filters at regular
intervals. The filter protects the compres-
1
GB
Publicidad
Tabla de contenido
