Kopp Radio dialer alarm Instrucciones De Manejo página 13

Recording and storing your own text message
• 4 text messages of 8 seconds each are available.
• 2 text messages (T1 and T2)  are possible in
connection with the alarm unit or in connection
with alarms.
• 4 recorded messages (T1, T2, T3, T4)  are
possible in connection the central operating unit.
Recorded message 1 (T1): in the event of an alarm.
Recorded message 2 (T2): predefi ned when pro
Recorded message 3 (T3): not predefi ned. Freely
Recorded message 4 (T4): not predefi ned. Freely
When recording your own messages (T1, T2, T3, T4)
press the following button combination (each button
individually):
For text 1:
• First switch device "OFF" (inactive) .
• Press the buttons  in the following sequence:
Press * (asterisk), T1, # (hash).
• Recording text for 2, 3 and 4 follows the same
Triggered by alarms or the
alarm unit.
blems occur with the
power supply. Triggered
by the dialer, alarm unit
central operating unit.
available in connection
with the central operating
unit.
available in connection
with the central operating
unit.
procedure.
• The microphone is switched on for recording.
• The green and yellow LEDs  fl ash at different
speeds.
• Record your own message (max. 8 seconds).
• Hold the device  near to your mouth and
speak load and clearly.
• At the end of the recording period a short and a
long beep can be heard ( ). long beep can be heard ( long beep can be heard (
• The yellow LED  goes out.
• The green LED  comes on.
The recorded text is automatically stored.
Deleting a message (example for T1)
Press the buttons  in the following sequence:
Press * (asterisk), 0 (zero), T1
Deleting texts for T2, to T4 follows the same procedure: Deleting texts for T2, to T4 follows the same procedure:
• To confi rm deletion one long single tone can be
heard and the yellow LED  fl ashes faster.
• The yellow LED  goes out
• The green LED  comes on.
The message has been deleted.
If there is no radio contact to the central operating
unit an error will be indicated when attempting to
delete texts T3/T4 .
After being programmed the dialer switches to
standby:
• i.e. one long beep can be heard 
• the yellow LED  fl ashes several times
• the green LED  is on permanently.
13
 ).
13