Kopp Radio dialer alarm Instrucciones De Manejo página 15

If several telephone numbers have been stored,
repeat the procedure.
Please ensure that a different memory location is
selected for each new telephone number.
Otherwise the memory location will be overwritten
and the previously stored telephone number will be
lost.
Teaching alarms, alarm unit and central operating
unit
Press the following button combination :
• PROG , * (asterisk) .
• The green  and the yellow  LEDs are on
together.
• The learning mode is switched on for 20 seconds.
• Subsequently a test alarm is triggered via the
alarms or at the alarm unit. (Please follow the
separate operating instructions for alarms and
the alarm unit.)
• As soon as the dialer recognizes the device to
teach the red LED  fl ashes slowly 3 times.
When the dialer is combined with a central operating
unit, confi rmation is sent back to the central unit.
Red LED  fl ashes slowly 4 times. A maximum of 15
sensors can be taught.
Memory full:
The yellow LED  fl ashes quickly for 2 seconds.
Leaving the learning mode prematurely:
Press the "PROG" button .
Deleting taught transmitters
• First press the the "PROG" button , then
press 0 (zero).
• Confi rmation of deletion:
The yellow LED  comes on, then fl ashes briefl y
and goes out.
If the programming was unsuccessful:
Please refer to the FAQs under www.free-control.com.
Simulating alarm scenarios
Switch the dialer "OFF" (inactive) 
Press the following button combination :
• PROG, 9 (nine)
• All LEDs  fl ash slowly.
• All stored telephone numbers in memory locati-
ons 1-8 are called and voice messages communi-
cated.
• Text 1 (T1) is played loud.
• All telephone numbers are called.
• Text 1 (T1) is played back to the recipient several
times.
The whole procedure runs once through and the
alarm simulation terminates.
In case of alarm
When the dialer is switched "OFF" (inactive) :
• The green LED is on permanently.
• The red LED  blinks slowly for the whole period
of the alarm.
• No voice messages are sent.
15