Connecting The Resolv 50A - Samson RESOLV 50a Manual Del Usuario

Connecting the RESOLV 50a

RESOLV 50a Quick Connections
Note: Before plugging in and turning on, remember the "LAST ON, FIRST OFF" rule of power amplifiers (and powered
monitors). When powering up your system, be sure that all the wires are connected, turn your mixer and any other out-
board gear on, and then turn your RESOLV 50a's on last. When powering down, turn your RESOLV 50a's off first and then
your mixer and outboard gear. This will prevent any turn-on or turn off "thumps" from possibly damaging the speakers.
The RESOLV 50a connections can be made via one of the two rear panel Audio Inputs. You can use RCA input for unbal-
anced, -10dBV level signals, or the 1/4-inch input for balanced +4dBu level signals. Follow the simple steps and diagram
below for a quick connection using a standard recording console's Control Room outputs.
• Lower your mixer's master outputs to all the way off.
• Connect the mixer's left Control Room output to the left-side RESOLV 50a LINE INPUT and the mixer's right
Control Room output to the right-side RESOLV 50a LINE INPUT.
• Set the RESOLV 50a's input Volume control to the 12 o'clock position.
• Run an audio signal (like some music from a CD) through your mixer and raise the Control Room level to a com-
fortable listening level.
8