Connecting To The Resolv120A Subwoofer; Resolv 50A With Mono Sub - Samson RESOLV 50a Manual Del Usuario

RESOLV 50a with Mono Sub

Adding a subwoofer (and extended low frequency response) to your RESOLV 50a system is easy using the RESOLV 50a's
LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a pair of RESOLV 50a satellite
speakers. For a detailed wiring diagram, see the section "RESOLV 50a Connections" on page 12. Follow the steps in the
diagram below to set up your system:
FROM MIXER
R
L
• Lower your mixer's master outputs to all the way off.
• Connect the mixer's Left output to the RESOLV 120's LEFT PREAMP LEVEL INPUT and the mixer's Right output to
the RESOLV 120's RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120's LEFT PREAMP LEVEL OUTPUT to
the input of the left RESOLV 50a, and the RESOLV 120's RIGHT PREAMP LEVEL OUTPUT to the input of the right
RESOLV 50a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable
listening level.
• Now adjust the SWEEP control to the desired frequency. A good place to start is about 70 Hz. You can also use
your ears by adjusting the SWEEP control to the frequency that sounds good to you.

Connecting to the Resolv120a Subwoofer

dBr
-10 INPUT
5
0
-9
-15
+4 INPUT
-21
-27
10 100 1K 10K 30K
CROSSOVER FREQUENCY (Hz)
RESOL RESOLV MONIT RESOLV MONIT ORS CAN A
EXTREMELY HIGH SOUND EXTREMELY HIGH SOUND EXTREMEL
PRESSURE LEVELS. USE CA PRESSURE LEVELS. USE CA PRESSURE LEVELS.
S/N OR HEARING DAMA S/N OR HEARING DAMA S/N GE MA
POWER 115-230 vac ó 50Hz/60Hz 175W
RATING
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
www.samsontech.com
DESIGNED AND ENGINEERED IN THE UNITED STAT THE UNITED ST ES BY SAMSON THE UNITED STAT
dBr
5
0
-9
-15
-21
-27
10 100 1K
CROSSOVER FREQUENCY (Hz)
POWER 115-230 vac ó 50Hz/60Hz 175W
RATING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
10 Inch Long Throw Transducer 120 Watt Amplifier
11
10K 30K