Attaching the bracelet
the pivot pin is correctly seated.
Finely adjusting of the bracelet length
Your metal bracelet is equipped with a special mechanism for making fine
adjustments that allows you to make minor modifications to the length of
your bracelet.
the bracelet locks into place in this new position.
Attach the component parts of the bracelet link to
the connection point and push the pivot pin into the
bracelet from the side (1).
Using the special tool provided, now press the secur ing
pin downwards (2) and, at the same time, slide the
pivot pin back into the bracelet until it lies flush (3). The
securing pin must be brought up flush with the upper
edge of the securing link. Please be sure to check that
To make the bracelet longer, push the button labelled
"IWC", which is in the middle of the cover of the
bracelet clasp, and continue to hold it down. Carefully
pull the bracelet out from underneath the small end
of the clasp cover. As soon as you let go of the button,
To make the bracelet shorter, simply push it back under
the small end of the clasp cover. The bracelet locks into
place automatically in this new position.