Emglo Air Mate AM782HC4V Manual De Instrucciones página 5

All manuals and user guides at all-guides.com
• Sprayed materials such as • Work in an area with good
paint, paint solvents, paint cross ventilation. Read and
remover, insecticides, weed follow the safety instructions
killers, may contain harmful provided on the label or safety
vapors and poisons. data sheets for the materials
you are spraying. Always use
certified safety equipment:
OSHA/MSHA/NIOSH
respiratory protection designed
for use with your specific
application.
DANGER: RISK OF INJURY OR PROP ER TY DAMAGE WHEN
TRANSPORTING OR STORING
WHAT CAN HAPPEN
• Oil can leak or spill and could • Always place compressor
result in fire or breathing on a protective mat when
hazard; serious injury or transporting to protect against
death can result. Oil leaks will damage to vehicle from leaks.
damage carpet, paint or other Remove compressor from
surfaces in vehicles or trailers. vehicle immediately upon arrival
at your destination. Always keep
compressor level and never lie
on its side.
Air Tank: The air tank on your Air Compressor is designed and
may be UM coded (for units with air tanks greater than 6" (152 mm)
diameter) according to ASME Section VIII, Div. 1 rules. All pressure
vessels should be inspected once every two years. To find your state
pressure vessels inspector, look under the Division of Labor and
Industries in the government section of a phone book or call 1-888-
88EMGLO (1-888-883-6456) for assistance.
The following conditions could lead to a weakening of the air tank,
and result in a violent air tank explosion:
• Failure to properly drain
condensed water from
HOW TO PREVENT IT
air tank, causing rust and
thinning of the steel air tank.
• Modifications or attempted
repairs to the air tank.
• Unauthorized modifications
to the safety valve or any
other components which
control air tank pressure.
5
WARNING: RISK OF BURSTING
WHAT CAN HAPPEN HOW TO PREVENT IT
• Drain air tank daily or after
each use. If air tank develops
a leak, replace it immediately
with a new air tank or replace
the entire compressor.
• Never drill into, weld, or make
any modifications to the air
tank or its attachments. Never
attempt to repair a damaged or
leaking air tank. Replace with a
new air tank.
• The air tank is designed
to withstand specific
operating pressures. Never
make adjustments or parts
substitutions to alter the factory
set operating pressures.