Maintenance; Cleaning The Air Filter; General Maintenance - Black Max BM26BV Manual Del Operador

Normal maintenance, replacement or repair of emission
control devices and systems may be performed by any
qualified repair establishment or individual with original or
equivalent parts. Warranty and recall repairs must be per-
formed by an authorized service center; please contact
customer service for assistance.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from spark
plug. Failure to follow these instructions can result in
serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, lubricant, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating lubricants, etc., come in con-
tact with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal injury.

MAINTENANCE

CLEANING THE AIR FILTER

See Figures 14 - 15.
For proper performance and long life, keep air filter clean.
 Remove the air filter cover by turning the dial counter-
clockwise while gently pulling on the cover.
 Rinse filter with clean water.
 Gently squeeze filter until excess water is removed.
Replace filter.
 Place the air filter cover back on the unit. Turn dial clock-
wise until cover is secure.
CLEANING THE EXHAUST PORT, MUFFLER
AND SPARK ARRESTOR
NOTICE:
The spark arrestor on this product has not been evalu-
ated by the USDA Forest Service and cannot be used
on U.S. forest lands. In addition, product users must
comply with Federal, State, and local fire prevention
regulations. Check with appropriate authorities. Contact
customer service or a qualified service center to purchase
a replacement spark arrestor.
NOTE: Depending on the type of fuel used, the type and
amount of lubricant used, and/or your operating conditions, the
exhaust port, muffler, and/or spark arrestor screen may be-
come blocked with carbon deposits. If you notice a power
loss with your gas powered tool, you may need to remove
these deposits to restore performance. We highly recom-
mend that only qualified service technicians perform this
service.
The spark arrestor must be cleaned or replaced every
50 hours or yearly to ensure proper performance of your
product. Spark arrestors may be in different locations de-
pending on the model purchased. Please contact customer
service or a qualified service center for assistance.
Never run the blower without a muffler equipped with a
spark arrestor in place. Failure to do so could result in a
fire that could cause serious personal injury.
Page 11 — English
WARNING: